Code Blue Corporation | Knowledge Base

Recent Articles
Remove Vinyl Graphics
I should advise you that our graphics are vandal resistant and difficult to remove. It can be done with a heat gun and razor if you are very careful, but the easiest and safest way is to use a rubber wheel attached to a power tool. If you can get ...
Condensation Inside CB1
The most common cause of condensation inside a Code Blue pedestal-type unit (CB1) is because there is not at least a ½ inch gap at the bottom of the unit to allow air flow inside. The bottom of the unit should not be sitting directly on the concrete ...
Anchor Bolt Epoxy Workaround Kit
Part number 40344 is what I call our “Anchor Bolt Epoxy Workaround Kit” and is not something we normally sell so we do not have a cut sheet on it. It was an alternative mounting kit that we put together for the rare instances of when someone ...
Anchor Bolt Epoxy Workaround Kit
Part number 40344 is what I call our “Anchor Bolt Epoxy Workaround Kit” and is not something we normally sell so we do not have a cut sheet on it. It was an alternative mounting kit that we put together for the rare instances of when someone ...
CB2-e Custom Camera Process and Pricing
Code Blue can build a CB2-e unit with a custom camera if the following is met: Charges are as follows: $650 – One time Engineering set up fee $150 – Cutout charge per CB2-e Customer will need to provide: -A CAD drawing with enough detail for us to ...

Popular Articles
How to Program the IA4100 Speakerphone
General Programming To program an IA4100, IA3100, and IA500 series phone you need to use an analog phone or an IP phone that pushes DTMF tones and call the extension or phone number of the Emergency phone. When you dial the phone number to the Code ...
IA4100 Disconnects Upon Called Answered.
How do I get the IA4100 phone to hang up after the called party hangs up? By default, the IA4100 is looking for a 200 millisecond wink to hang-up the call. If your phone system is not issuing a 200 millisecond wink there are additional hang-up ...
Static On The Line - 3000/3100
Because the CB3000, CB3100 are half-duplex, audio switching phones, hum and static can block audio by the duplex controller in one direction. The cause of the noise requires locating and resolving appropriately: The noise may be internal to the CB ...
Programming - AED Key Fob
Programming involves opening the Code Blue unit (our special security bit will be required) and once inside you will see the door controller (pictured below). To program, the tech will insert a small screw driver into the hole next to the green ...
CB2-e Custom Camera Process and Pricing
Code Blue can build a CB2-e unit with a custom camera if the following is met: Charges are as follows: $650 – One time Engineering set up fee $150 – Cutout charge per CB2-e Customer will need to provide: -A CAD drawing with enough detail for us to ...